Tool:Vinylsnijder

{{{Name}}} {{#ifexist: | | Tool_Vinylsnijder_Picture.jpg

Eet vinyl (20cm breed)

Vinyl is aanwezig in meerdere kleuren

Er is Windows and Mac-software meegeleverd. Onder Linux wordt de cutter herkend als Parallel-over-USB device.

Werkt naar behoren met https://www.codelv.com/projects/inkcut/ onder Linux en OSX (Windows niet getest). Vraag Gebruiker:raboof eventueel voor hulp.

We zijn ook een grotere oudere vinylsnijder aan het opknappen, de AristoVinylsnijder

Zoektermen: vinylcutter, snijplotter, hobbyplotter, snijplotter

gmc's experience with ubuntu 18.04

Connect the plotter with usb to your laptop
Install the printer in your system (cups) by browsing to localhost:631 (not sure if this is needed, I don't think so)
Choose 'Raw' as the 'Make', 'Raw Queue' as model
Start inkcut
- Device->Setup
  - General: driver = Silhouette Portrait
  - General: Check customize, set width to 24cm, length 300cm
  - Device: Output: check 'Swap X/Y'
  - Connection: Type = parallel port, Port will be something like /dev/usb/lp2
- On the left, activate 'Material'
- Set the plot area (first number on top is width, i set it to 240mm for the metamark e series sheets, height i didn't measure (my design wasn't that tall)
- Now you can load a design, maybe set 'Graphic Copies' to fill the sheet
- Then Device->Send to Device et voila